Installation & Repair

How much does a control and valve installer and repairer make?

The median control and valve installer and repairer in the United States earns $74,340 per year, about $35.74 an hour. That is the midpoint of the profession: half of all control and valve installers and repairers earn more, and half earn less.

Median annual salary
$74,340
Median hourly wage
$35.74 /hr
Employed in the U.S.
48,240

Source: BLS OEWS, May 2025. SOC code 49-9012.

Control and valve installer and repairer salary range

Pay for control and valve installers and repairers spans a wide band. The lowest paid 10 percent earn under $45,910 a year, while the highest paid 10 percent take home more than $112,500. The average (mean) wage of $76,210 runs a bit higher than the median, which is normal for jobs where a group of top earners pulls the average up.

Percentile Annual Hourly
10th percentile $45,910 $22.07 Lowest paid
25th percentile $54,950 $26.42
Median (50th) $74,340 $35.74 Midpoint
75th percentile $97,120 $46.69
90th percentile $112,500 $54.09 Highest paid

Figures are national wage estimates for control and valve installers and repairers, except mechanical door (SOC 49-9012), U.S. Bureau of Labor Statistics, OEWS, May 2025.

Control and valve installer and repairer salary by state

Where you work changes the paycheck. Control and valve installers and repairers earn the most in Rhode Island at $110,900 a year, and the least in Mississippi at $48,670. The table below lists every state with published data, ranked by median annual salary.

State Median annual Employed
Rhode Island $110,900 110
Alaska $109,450 30
Connecticut $104,690 360
North Dakota $103,580 270
Washington $102,870 450
New York $101,150 4,170
California $100,260 4,310
Wyoming $100,030 290
District of Columbia $98,810 50
South Dakota $98,090 150
Oregon $97,110 490
Michigan $96,890 2,240
New Jersey $96,510 1,000
Massachusetts $95,520 1,320
Nebraska $88,610 440
Idaho $84,390 180
Iowa $83,830 820
Vermont $82,010 40
Hawaii $81,850 110
West Virginia $79,000 610
Pennsylvania $78,120 1,330
Kansas $77,720 290
Missouri $77,650 620
Ohio $76,920 1,230
Minnesota $76,640 710
Wisconsin $76,540 980
Delaware $75,720 150
Utah $73,090 300
Nevada $72,310 70
Virginia $68,000 820
New Mexico $67,520 320
Louisiana $66,730 560
Maryland $66,500 800
Maine $66,240 190
North Carolina $64,820 1,440
Colorado $63,770 1,190
Oklahoma $62,780 1,320
Illinois $61,980 250
Alabama $61,670 430
Kentucky $61,450 450
Arkansas $61,440 440
New Hampshire $61,380 220
Georgia $61,070 870
Arizona $60,570 840
Indiana $60,170 760
Montana $58,940 50
Texas $58,230 11,630
Florida $57,460 1,250
Tennessee $57,010 670
South Carolina $50,800 420
Mississippi $48,670 170

State median wages for control and valve installers and repairers, except mechanical door (SOC 49-9012), U.S. Bureau of Labor Statistics, OEWS state files, May 2025. States where the BLS does not publish a median are not shown.

Job outlook for control and valve installers and repairers

The BLS projects employment of control and valve installers and repairers to grow 4.3% from 2025 to 2035. That is about as fast as the 3.5% average for all occupations. That works out to roughly 50,400 jobs in 2025 moving toward 52,600 by 2035.

Across the decade, the BLS expects about 3,600 openings a year for control and valve installers and repairers. Most come from the need to replace workers who move to other jobs or leave the workforce, on top of any new positions from growth.

Source: U.S. Bureau of Labor Statistics, Employment Projections program, 2025-35 (Table 1.2, Occupational projections and worker characteristics).

How to become a control and valve installer and repairer

The typical entry-level education for control and valve installers and repairers is a high school diploma or equivalent, according to the BLS. New hires typically complete moderate-term on-the-job training to reach full competency.

A four-year college degree is usually not required to start, which makes this one of the jobs you can enter without a bachelor's degree. See more high paying jobs without a degree .

Education, training, and experience data: U.S. Bureau of Labor Statistics, Employment Projections program.

What affects how much a control and valve installer and repairer earns

Certifications, the type of equipment worked on, employer, and region drive most of the pay difference. Flat-rate pay and overtime can push experienced techs well above the median.

Location is one of the clearest factors. The gap between the top paying state (Rhode Island, $110,900) and the lowest (Mississippi, $48,670) shows how much geography alone can move the number, before experience or specialization.

About 48,240 people work as control and valve installers and repairers in the United States. At $74,340 a year, the job pays above the $50,980 median for all U.S. jobs.

Control and valve installer and repairer salary FAQ

How much does a control and valve installer and repairer make an hour?

The median hourly wage for a control and valve installer and repairer is $35.74. The middle half of control and valve installers and repairers earn between $26.42 and $46.69 per hour.

What is the highest control and valve installer and repairer salary?

The highest paid 10 percent of control and valve installers and repairers earn more than $112,500 per year. Top earners usually have the most experience and work in the best paying regions and industries.

How much does a control and valve installer and repairer make a year?

The median annual salary for a control and valve installer and repairer is $74,340. The average (mean) wage of $76,210 runs a bit higher than the median, which is normal for jobs where a group of top earners pulls the average up.

Is being a control and valve installer and repairer a well paid job?

At $74,340 a year, a control and valve installer and repairer earns above the $50,980 median for all U.S. jobs. About 48,240 people work as control and valve installers and repairers in the United States.

Which state pays control and valve installers and repairers the most?

Rhode Island has the highest median salary for control and valve installers and repairers at $110,900 a year. Alaska ($109,450) and Connecticut ($104,690) follow. State medians come from the BLS OEWS state files, May 2025.

Is being a control and valve installer and repairer a good career?

Employment of control and valve installers and repairers is projected to grow 4.3% from 2025 to 2035, about as fast as the 3.5% average for all occupations. The BLS projects about 3,600 openings each year, from growth and from workers leaving the occupation.

Do you need a degree to become a control and valve installer and repairer?

No. The BLS lists the typical entry-level education for control and valve installers and repairers as a high school diploma or equivalent, so a four-year degree is usually not required to start.

Related salaries

See more in Installation & Repair salaries or browse the highest paying jobs in the U.S.

Sources. National and state wage and employment figures: U.S. Bureau of Labor Statistics, Occupational Employment and Wage Statistics (OEWS), May 2025 and the OEWS state files. Growth, openings, education, and training: U.S. Bureau of Labor Statistics, Employment Projections program (2025–2035). Every figure on this page is published by the BLS and is shown without adjustment. View the originals at bls.gov/oes and bls.gov/emp. Last updated 2026-05-15.